Jazrider JR-CBR-TM-023 Metal Shielded Ball Bearing Set for Tamiya CC-01 Platforms  [JR-CBR-TM-023]

TAMIYA CR-V / PAJERO / VW Touareg Metal Shielded RC Ball Bearing Set - Jazrider [JR-CBR-TM-023]
Price:
USD$6.57
Brand:
JAZRIDER
Model:
JR-CBR-TM-023
Condition:
Brand New
Available in warehouse
Write a review

Technical overview for CC-01 bearing replacement

The JAZRIDER JR-CBR-TM-023 provides 18 shielded metal bearings intended as direct replacements for common bushings on Tamiya CC-01 based CR-V, Pajero and VW Touareg kits. These bearings reduce friction at rotating interfaces and help maintain alignment under load.

Installation and service notes

Install bearings by pressing the outer race square into the hub or carrier. Avoid striking the inner race to prevent brinelling. Inspect housings for burrs and ensure a snug, concentric fit for best life expectancy.

Pack contents and sizing

  • 5 x 11 x 4mm (11 pieces)
  • 5 x 8 x 2.5mm (3 pieces)
  • 10 x 15 x 4mm (2 pieces)
  • 6 x 12 x 4mm (2 pieces)

What is the recommended press fit tolerance?

Aim for a light interference fit on the outer race, typically a few hundredths of a millimetre, to secure the bearing without excessive stress. Measure bores and outer diameters before installation.

Are these bearings rated for high RPMs in belt or gear drives?

Shielded small ball bearings perform well at typical RC drivetrain speeds. For sustained high RPM applications check heat and lubrication requirements and choose appropriate lubricant for shields.

What maintenance is advised for longevity?

Regularly clear grit from around the shields, top up with light oil if rotation feels gritty, and replace any bearing showing play or noise. Proper seating and clean housings extend service life.