TAMIYA CW-01 Aftermarket Front Lower Arm Stabilizer - JR-LB03-DB by JAZRIDER  [JR-LB03-DB]

Tamiya CW-01 Aluminum Front Lower Arm Stabilizer Mount (Blue)
Price:
USD$12.60
Brand:
JAZRIDER
Model:
JR-LB03-DB
Condition:
Brand New
Available in shop
Write a review

Aftermarket stabiliser mount description

This RC-scale front lower arm stabilizer mount is a metal replacement designed for the TAMIYA CW-01 chassis and supplied by JAZRIDER under model JR-LB03-DB. Fabricated from aluminium and finished in blue, the unit replaces the original plastic locating point to reduce flex under load and provide a firmer connection between the lower arm and chassis.

As an upgrade component it does not alter suspension geometry but increases stiffness at the lower arm pivot, which helps cut unwanted front-end movement, improves initial turn-in and produces a more consistent feel when adjusting roll and anti-roll settings for on-road driving.

Fitting requires routine maintenance steps: remove the stock plastic mount, reuse any existing bushings or washers, and secure the aluminium mount to the CW-01 front lower arm mounting points with the vehicle's original fasteners. No special tools are necessary.

What compatibility should I expect with other models?

The part is engineered for the CW-01 mounting pattern; while it may fit other chassis, compatibility should be verified by comparing the mounting points and clearances against those vehicles.

Any preparation needed before installation?

Check and transfer existing bushings and washers from the original mount, ensure mating surfaces are clean, then fasten the aluminium unit using the original screws supplied with the vehicle.

How does this upgrade assist with setup work?

By reducing flex at the lower arm pivot, the upgrade gives a firmer baseline that makes small changes to roll and anti-roll easier to evaluate and repeat during tuning sessions.