TAMIYA CW-01 Aftermarket Red Front Upright TA-50395L-RD by Jazrider  [TA-50395L-RD]

Aftermarket red aluminum uprights for CW-01

This Jazrider front upright is an RC-scale knuckle arm created for TAMIYA CW-01 based chassis. CNC machined from aluminum and finished in red anodize, the component replaces the stock front upright to provide a metal alternative that helps stabilise steering geometry under load. The description stays focused on fitment, installation steps, and tuning implications rather than making broad performance statements.

Fitting follows standard CW-01 procedures: remove the stock part, test-fit the Jazrider aluminium upright, and ensure clearance for the servo horn and drivetrain. Retain original mounting hardware when suitable, but inspect screw condition; check ball stud and pin alignment prior to final tightening. This item is intended as a direct replacement on compatible CW-01 hubs; always confirm compatibility with your chassis before full use.

From a setup angle, aluminium uprights are used to modify steering stiffness and feedback and should be combined with toe, caster, and steering link adjustments for best results. Perform alignment checks after installation and re-tighten hardware following an initial shakedown run.

Compatibility

• Tamiya Lunch Box
• Midnight Pumpkin
• Mitsubishi Montero
• Unimog 406
• CW-01
• CW01