Tamiya CW-01 Aluminum Clamp Wheel Hubs 2pc - JR-LB07-LB by Jazrider  [JR-LB07-LB]

Purpose-built clamp hubs for CW-01

These two clamp-type aluminum wheel hubs are supplied for Tamiya CW-01 wheel mounting and fit common vintage 1/10 buggy bodies including Hornet, Grasshopper, Frog, Lunch Box and Monster Beetle. The JR-LB07-LB hubs use an aluminum clamp format to provide a stable wheel-to-axle connection while maintaining a compact footprint suited to stock CW-01 arrangements.

Use is limited to the CW-01 mounting pattern models listed; check your wheel hex and axle stub dimensions before fitting. The hubs are direct-replacement style parts that match existing wheel hardware and mounting position rather than altering suspension geometry.

Fitting advice: remove the original hub, inspect axle threads and wheel hex for wear, slide the clamp hub into position on the axle or hex seat, confirm the wheel sits flush, and secure with the vehicle's original fasteners. Apply correct torque for small RC fasteners and verify there is no binding or excessive runout after installation.

Setup guidance: clamp-style aluminum hubs can improve remount repeatability and reduce deformation compared with thin pressed hubs. After installation, check wheel balance and runout and make incremental adjustments if tyre or wheel combinations change. These parts are intended for scale RC CW-01 models and do not modify steering or suspension geometry by themselves.