TAMIYA DF01 Rear Arm Aluminum Upgrade - JR-DF102-BK by Jazrider  [JR-DF102-BK]

Tamiya DF01 Top Force/ Manta Ray Aluminum Rear Suspension Arms (Black)
Price:
USD$13.50
Brand:
JAZRIDER
Model:
JR-DF102-BK
Condition:
Brand New
Available in shop
Write a review

Direct-Fit Rear Arms for DF-01 Series

This set of black-anodized aluminum rear suspension arms is intended as a direct replacement for DF01 rear arms on TAMIYA and Top Force vehicles. The components increase strength over stock plastic arms and provide a reliable reference point for chassis setup. Always check hinge pin length and mount hardware compatibility before installation.

Installation uses the DF01 rear upright mounting points and normally reuses factory fasteners; verify bearing fit and suspension geometry after fitting to maintain expected handling characteristics.

These arms are useful for tuning rear camber, toe and roll center with aftermarket linkages or shock positions and are designed exclusively for 1/10 scale RC buggies.

What checks should I do before fitting these arms?

Measure hinge pin lengths, inspect upright clearances, and ensure your bearings seat correctly to avoid binding after installation.

Can I keep original DF01 fasteners when upgrading?

In most cases yes; reusing original fasteners is common, but replace any worn pins or screws to maintain secure mounting.

Recommended care to keep the anodize intact?

Avoid abrasive cleaning, wipe away dirt after use and keep chemical exposure to a minimum to preserve the black anodized finish.