JAZRIDER JR-DT308-BK Steel Drive Shaft Set (2pcs) - Practical upgrade for Tamiya DT02/DT03/TT02B  [JR-DT308-BK]

Tamiya DT02/DT03/TT02B Steel Drive Shaft (2pcs)
Price:
USD$12.70
Brand:
JAZRIDER
Model:
JR-DT308-BK
Condition:
Brand New
Available in warehouse
Write a review

Practical steel drive shafts for hobbyist use

The JAZRIDER JR-DT308-BK drive shaft pair is intended as a durable replacement for the standard plastic shafts on Tamiya DT02, DT03 and TT02B models. These two steel pieces are supplied to integrate with the existing drivetrain layout on those kits and to reduce routine wear under normal running conditions.

Intended fit and limitations

These shafts are designed to be used with Tamiya plastic cup joints. They are not compatible with the Tamiya 53790 joint type, so confirm the cup joint fitted to your car prior to ordering.

Fitting guidance and service notes

Install the shafts using the vehicle's original fasteners and ensure each connection is tightened to avoid slippage. Regular visual checks and debris removal will maintain reliable operation over time.

Is this a direct replacement for the stock shafts?

Yes. The set is intended to replace the stock plastic drive shafts on the DT02, DT03 and TT02B, provided the model uses the compatible plastic cup joints.

Any special setup required after fitting?

No special setup is necessary. After installation, verify alignment and that all fixings are secure, then re-check after the first running session.

How should I look after them?

Perform routine inspections, remove any trapped dirt and confirm there is no excessive play. Replace the shafts if you see clear signs of wear or deformation.