Tamiya DT-03 Aftermarket Rear Hub Carrier JR-DT307-BK by Jazrider  [JR-DT307-BK]

Tamiya DT-03 Aluminum Rear Hub Carrier (Black)
Price:
USD$10.70
Brand:
JAZRIDER
Model:
JR-DT307-BK
Condition:
Brand New
Available in shop
Write a review

Aftermarket Rear Hub Carrier for DT-03

This replacement rear hub carrier suits the Tamiya DT-03 chassis and is supplied under model number JR-DT307-BK. Manufactured from aluminium, the carrier is offered as an aftermarket component to provide a metal mounting surface for rear suspension pivots and wheel spindles.

Intended usage is to swap out the stock plastic carrier for the aluminium unit to support routine servicing, setup changes and tuning where a firmer rear mounting point is desired. The part functions as a direct replacement on standard DT-03 mounting configurations.

Fitment guidance: remove the rear wheel and related drive or brake parts to access the hub area, retain original screws and spacers unless otherwise advised, and verify bearing seating and wheel alignment after installation. Ensure the rear suspension has full, unobstructed travel with no binding.

Tuning considerations: replacing a flexible plastic carrier with aluminium increases pivot stiffness and can lead to steadier alignment under load, which may alter the vehicle's rear-end feel when adjusting toe and camber. The exact handling outcome depends on the wider suspension setup.

Is this compatible with other models?

The carrier is designed for the Tamiya DT-03 mounting pattern. Verify dimensions if you plan to use it on different chassis or extensively modified cars.

Do I need special tools to fit it?

Standard hand tools are sufficient for most installations; use care when handling aluminium parts and torque fasteners appropriately to avoid striping threads.

Will this affect maintenance intervals?

Aluminium can change wear patterns slightly; inspect bearings, fasteners and mating surfaces more frequently after fitting to confirm there is no unexpected wear.