JAZRIDER JR-DT306-BK Black Aluminium Front Upright for Tamiya DT-03 - Practical Durability Upgrade  [JR-DT306-BK]

Tamiya DT-03 Aluminum Front Upright (Black)
Price:
USD$8.83
Brand:
JAZRIDER
Model:
JR-DT306-BK
Condition:
Brand New
Available in warehouse
Write a review

Practical aluminium upgrade for DT-03 steering

The JAZRIDER JR-DT306-BK upright replaces the DT-03 stock front knuckle with a black aluminium unit that improves long term durability and steady steering feedback. It is aimed at hobbyists seeking reliable, low-maintenance upgrades rather than race-only parts.

Sturdy construction for everyday use

Aluminium construction reduces deformation and wear versus plastic, helping maintain consistent steering geometry across repeated runs. This suits modders who prefer durable parts that require minimal attention between outings.

Straightforward bench installation

Installation follows the standard DT-03 mounting layout so the part fits without adapter plates. Typical home toolkits are adequate, and the replacement can be completed quickly for immediate use.

Is the JR-DT306-BK a direct replacement for the OEM knuckle?

Yes. The JR-DT306-BK is produced to match the DT-03 steering mounting points and functions as a direct substitute for the stock plastic knuckle.

What workshop tools are recommended for fitting?

A set of small screwdrivers, hex drivers and a torque check on pivot screws are sufficient. Use light thread locker where appropriate to prevent loosening under track use.

How should I inspect the upright after runs?

Check for burrs, loose fasteners and play in joints. Clean grit off the aluminium and re-tighten mounting screws as part of routine maintenance.