JAZRIDER JR-DT304-BK Black Aluminium C Hub for Tamiya DT-03  [JR-DT304-BK]

Tamiya DT-03 Aluminum C Hub (Black)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-DT304-BK
Condition:
Brand New
Available in warehouse
1 Reviews
Write a review

Practical Upgrade for DT-03 Steering Geometry

The JAZRIDER JR-DT304-BK black aluminium C hub is a practical reinforcement for the Tamiya DT-03 front end. Machined to match DT-03 mounting points, it reduces component deflection and helps preserve alignment under load for reliable handling sessions.

Material and Serviceability

Aluminium construction gives improved dimensional stability compared with the original plastic hub. This results in less play at the steering knuckle and simplifies maintenance cycles, lowering the need for frequent part replacement.

Fitment Procedure for Hobbyists

Installation is a direct swap into the DT-03 assembly. Remove the stock hub, transfer any reusable hardware, fit the JAZRIDER hub, and torque fasteners appropriately. Check steering travel and toe after install for consistent setup.

 

Product Reviews
1 Reviews
rating
Excellent service. Package arrived on time. All contents were there. Will buy again from seller in the future for Tamiya products/hop-ups.

Does the JAZRIDER hub alter suspension geometry?

No. The JR-DT304-BK preserves factory geometry while improving rigidity at the pivot points.

Are there recommended torque values?

Follow the chassis manufacturer torque ranges where applicable and ensure hardware is secure without over tightening to avoid thread damage.

What routine checks should I perform?

Inspect for play in the steering linkage, verify hub fastener tightness after initial runs, and clean pivot areas to prevent grit buildup.