Tamiya DT-03 Aluminum Rear Hub Carrier Upgrade - JR-DT307-RD by Jazrider  [JR-DT307-RD]

Tamiya DT-03 Aluminum Rear Hub Carrier (Red)
Price:
USD$10.70
Brand:
JAZRIDER
Model:
JR-DT307-RD
Condition:
Brand New
Available in shop
Write a review

Upgraded DT-03 Rear Hub Carrier, Red Anodized

The JR-DT307-RD aluminum rear hub carrier is a precision replacement for the Tamiya DT-03 chassis. The red anodized finish and aluminum build lower flex versus typical plastic OEM carriers.

Performance overview: swapping to an aluminum carrier reduces unwanted compliance at the rear hub and helps maintain consistent suspension geometry when running more aggressive setups. This yields more repeatable handling during tuning sessions.

Installation summary: remove the rear wheel and original carrier, transfer bearings or pins to the new unit, then bolt the aluminum carrier in place with the original fasteners and the correct hex driver. Check wheel alignment and suspension travel after installation and recheck fastener torque after a short test.

Fitment reminder: intended for DT-03 chassis; confirm dimensions before attempting to fit on different Tamiya platforms. This product is an RC upgrade component, not intended for full-size vehicle use.

What should I check before fitting this carrier?

Ensure the rear hub mounting pattern and bearing locations match the DT-03 specification and move over any bearings or locating pins from the original carrier.

Is any special hardware required?

No special hardware is typically needed; use the chassis original fasteners and a proper hex driver, and verify torque during initial runs.