TAMIYA DT-03 Front Lower Suspension Arm JR-DT300-OR by Jazrider  [JR-DT300-OR]

Tamiya DT-03 Aluminum Front Lower Suspension Arm (Orange)
Price:
USD$15.10
Brand:
JAZRIDER
Model:
JR-DT300-OR
Condition:
Brand New
Available in shop
Write a review

Front lower suspension arm tailored for the DT-03

This front lower suspension arm fits the TAMIYA DT-03 chassis and is offered as model JR-DT300-OR. The part is machined from anodised orange aluminium to replace the stock plastic lower arm while matching DT-03 mounting points.

Functionally the aluminium arm reduces flex at the suspension pivot, improving the repeatability of small setup adjustments. It is intended to be used with standard DT-03 suspension components and ball cups; check existing fasteners and ball stud alignment prior to installation.

Installation advice: transfer original mounting hardware where suitable, align the arm with the hub carrier and steering linkage, tighten fasteners to a moderate torque to avoid damaging threads, and verify suspension travel and steering clearance after fitting.

Does this arm fit without alteration?

It is produced to the DT-03 lower arm mounting specification; check that your particular DT-03 variant uses the same mounting points for a direct fit.

Will I need to change ball studs or linkages?

Most installations reuse stock ball studs and linkages, but verify spacing and replace any worn hardware to ensure correct geometry and safe operation.

What practical benefit does aluminium offer?

Aluminium provides a firmer mounting platform that preserves alignment under load, making setup adjustments more predictable; test changes gradually to understand their effects.