TAMIYA Front Damper Stay Upgrade Compatible with Thunder Dragon / Thunder Shot JR-TSD03-RD by Jazrider  [JR-TSD03-RD]

Tamiya Thunder Dragon/ Thunder Shot Aluminum Front Damper Stay (Red)
Price:
USD$7.60
Brand:
JAZRIDER
Model:
JR-TSD03-RD
Condition:
Brand New
Available in shop
Write a review

TAMIYA-Compatible Aluminum Front Damper Stay

This aluminum front damper stay replaces the stock plastic unit on TAMIYA Thunder Dragon and Thunder Shot. Its stiffer construction provides a more stable mounting point for the dampers, reducing unwanted flex and offering a consistent baseline for front suspension adjustments.

Installation is a direct replacement operation: remove the existing stay, transfer any caps or spacers, and fasten the new stay using the original screws. Use the correct hex drivers, ensure parts align before final tightening, and avoid over-torquing. Thread locker may be applied to steel screws if suitable for the surrounding components.

In practice this part improves repeatability at the damper mount rather than altering suspension geometry. Expect steadier damper positioning and easier tuning of spring rates and damping; always check for clearance with shock towers and steering linkages after fitting.

What are the main benefits of swapping to an aluminum stay?

An aluminum stay reduces flex at the damper mount, producing more consistent responses from the shocks and making setup changes more repeatable across runs.

Is fitting this stay a complex job?

No, it is a straightforward swap using the original hardware. Fit loosely to check alignment, then tighten to the correct torque to avoid stripping the threads.

Will the anodized finish affect mounting tolerances?

The anodize is a thin protective layer and should not change fitment. Clean mating surfaces and confirm hole alignment during installation to ensure correct seating.