Tamiya Hornet EVO (58742) Aftermarket Front Lower Arm Mount Plate JR-THNE07-BK by Jazrider  [JR-THNE07-BK]

Price:
USD$7.00
Brand:
JAZRIDER
Model:
JR-THNE07-BK
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminium front lower arm mount for Hornet EVO

This aluminum front lower arm mount plate is supplied as a direct-fit aftermarket replacement for the Tamiya Hornet EVO (58742) 1/10 scale buggy. The plate, model JR-THNE07-BK, replaces the stock plastic mounting surface with a black metal component intended to provide a firmer mounting point for the front suspension lower arm.

The part bolts to the front lower arm area of the Hornet EVO chassis using the chassis' existing mounting points and acts as the interface between the lower arm and the chassis. As an aluminium upgrade it is intended to reduce flex at the mounting area compared with the original plastic plate, which can help keep suspension geometry consistent during setup and on-track runs.

Fit this plate when working on camber, droop or front-end geometry; verify all clearances before final assembly and use appropriate torque when tightening fasteners to avoid overtightening.

Does this come as a direct replacement for the Hornet EVO?

Yes, JR-THNE07-BK is listed for the Hornet EVO (58742) and is intended to replace the stock front lower arm mount without modification, provided the chassis is unaltered.

Any advice on torque values for installation?

Use standard RC torque recommendations for small chassis fasteners and avoid overtightening into aluminium; check screws after initial test runs for loosening.

What should I check after fitting the plate?

After installation, confirm lower arm travel, steering clearance and suspension geometry, and re-measure camber and droop to ensure settings remained as intended.