TAMIYA Hotshot Rear Suspension Crank & Ball Rod Set JR-THS09-RD by Jazrider  [JR-THS09-RD]

Tamiya Hotshot Rear Suspension Crank (Parts E2, E4, E6) With Ball Rod Set (Red)
Price:
USD$8.40
Brand:
JAZRIDER
Model:
JR-THS09-RD
Condition:
Brand New
Available in shop
Write a review

Hotshot rear crank and red rod replacement kit

This JAZRIDER JR-THS09-RD kit supplies a rear suspension crank assembly and a coordinated red ball rod set for use with the TAMIYA Hotshot RC chassis. The parts correspond to the Hotshot E2, E4 and E6 positions and are offered as straightforward replacement pieces for repair or organised spare use.

Installation follows the usual Hotshot procedure: remove the rear arm assembly, move any required bearings across, and secure the ball rods onto the crank ends with the original ball studs. Cycle the suspension to confirm smooth travel and that no binding occurs at full compression or droop before finalising fastenings.

Use the kit to restore factory pivot geometry after long service life or as a like-for-like spare to maintain consistent rear behaviour during setup changes on Hotshot models.

Is this a direct replacement for Hotshot rear linkage parts?

Yes, the kit targets the E2, E4 and E6 rear positions on Hotshot chassis as direct replacement components.

Do I need to change other rear parts when fitting this set?

Not usually; transfer any reusable bearings and check the rest of the rear linkage for wear, replacing additional parts only if necessary to maintain geometry.

Are these suitable as track spares?

Yes. The set is compact and designed for quick replacement, making it useful as a trackside spare to restore consistent handling during events.