JAZRIDER JR-THS09-BK Rear Suspension Crank and Ball Rod Set for Tamiya Hotshot (Black, Parts E2, E4, E6)  [JR-THS09-BK]

Tamiya Hotshot Rear Suspension Crank (Parts E2, E4, E6) With Ball Rod Set (Black)
Price:
USD$6.50
Brand:
JAZRIDER
Model:
JR-THS09-BK
Condition:
Brand New
Available in warehouse
Write a review

Technical Overview of the JAZRIDER Rear Crank Set

The JAZRIDER Rear Suspension Crank Set (Parts E2, E4, E6) with Ball Rod in black is a practical replacement for worn rear linkage on the Tamiya Hotshot. Designed for straightforward maintenance, the set restores intended geometry and consistent rear articulation.

Engineering Notes

These parts focus on durable performance and reproducible fit. The crank and ball rod interface with standard Hotshot mounting points to limit setup variation and maintain predictable suspension travel under load.

  • Compatibility: Matches the Tamiya Hotshot specification for E2, E4 and E6 mounting locations.
  • Durability: Selected material and finish aim to resist routine wear and keep pivot play low.
  • Color: Black finish for unobtrusive integration with typical Hotshot components.

Service and Fitment Guidance

Inspect pivot tolerances during installation and verify free movement through the full suspension cycle. Use the Hotshot service notes to ensure correct reassembly and to retain factory alignment and performance.

What checks should be done after fitting?

Verify that linkage pivots rotate smoothly, confirm no binding across full travel and torque all fasteners to the values advised in the Hotshot manual.

Can I reuse the stock ball ends?

If the stock ball ends show no wear and seat securely, they can be reused, but replacing worn balls will help maintain precise steering feedback.

Any recommended inspection intervals?

Check linkages after heavy sessions and include a quick inspection in routine maintenance every few outings to catch developing wear early.