Tamiya Hotshot Stabilizer Stay Set - JR-THS03-RD (2pcs) by Jazrider  [JR-THS03-RD]

Tamiya Hotshot, Hotshot II/2 Aluminum Stabilizer Stay (2pcs) (Red)
Price:
USD$4.65
Brand:
JAZRIDER
Model:
JR-THS03-RD
Condition:
Brand New
Available in shop
Write a review

Aftermarket stabilizer stays for Hotshot models

This 2-piece red anodized aluminum stabilizer stay set fits Tamiya Hotshot and Hotshot II/2 buggies, replacing the standard plastic parts to provide a firmer stabilizer link mount and more consistent roll response.

Intended for chassis tuning, the aluminum stays change the stiffness at the stabilizer mount and influence how the suspension and stabilizer share load under cornering. Use them when adjusting front/rear roll balance or testing different shock settings.

The set contains 2 pcs and fits with routine hand tools. Inspect and reuse compatible screws or spacers where appropriate, and check link geometry after fitting to maintain correct handling characteristics.

Are these direct-fit replacements for the stock parts?

They are designed to use the stock mounting locations on Hotshot and Hotshot II/2 chassis and generally accept the same hardware where dimensions match.

What should I inspect after installation?

Verify link geometry, confirm ride height and steering alignment, and ensure fasteners are secure but not over-torqued to prevent distortion.

Can these stays bend or fail in a crash?

Aluminum is tougher against repeated flexing than plastic but can bend under heavy impact. Inspect for deformation after collisions and replace if necessary.