TAMIYA Hotshot, Super Hotshot, Hotshot II Aluminum Gear Box Stay w/ Stabilizer Mount - JR-THS08-GU by Jazrider  [JR-THS08-GU]

Tamiya Hotshot, Super Hotshot, Hotshot II Aluminum Gear Box Stay w/Stabilizer Mount Set (Gun Metal)
Price:
USD$8.40
Brand:
JAZRIDER
Model:
JR-THS08-GU
Condition:
Brand New
Available in shop
Write a review

Aluminum gearbox stay designed for TAMIYA Hotshot cars

This aluminum gear box stay with stabilizer mount is an RC-scale replacement part designed for TAMIYA Hotshot family models. It provides a rigid mounting point for the gearbox while adding a stabilizer mount to help control lateral movement under load. The finish is gun metal and the component is intended for hobby-grade model use only.

Compatibility follows the original product scope: fits Hotshot and Super Hotshot for both front and rear gearboxes, and fits Hotshot II for the front gearbox only. Confirm which gearbox position you are servicing before ordering to ensure the correct location of the part on your chassis.

Installation is direct-replacement style for the stock stay on supported TAMIYA chassis, using the existing mounting positions and fasteners from the plastic stay. The part's role in setup is mechanical: improve chassis rigidity around the gearbox, provide a mounting point for the stabilizer, and help maintain gear alignment during tuning and track use.

What models are covered by this stay and where does it mount?

The stay is made to fit Hotshot and Super Hotshot in both front and rear gearbox positions, while Hotshot II compatibility applies only to the front gearbox. Always check the gearbox location on your chassis prior to purchase.

Does fitting this part require alternative screws or brackets?

No special brackets are required; the stay uses the original mounting points and hardware. Replace any worn fasteners with equivalent items to ensure a secure installation.