Tamiya M-05/M-06/MF-01X Aftermarket Rear Arm, Aluminium - JR-M502-LB by Jazrider  [JR-M502-LB]

Tamiya M05/M06/MF-01X Aluminum Rear Suspension Arms (Light Blue)
Price:
USD$9.90
Brand:
JAZRIDER
Model:
JR-M502-LB
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminium rear arm overview

JR-M502-LB is an aluminium rear suspension arm made for the Tamiya M-05, M-06 and MF-01X chassis as a direct-fit alternative to stock plastic arms. It is intended to reduce flex and extend service life while keeping the original mounting interfaces.

Confirm the arm matches your chassis mounting points before fitting. Installation follows the same steps as replacing a stock arm: remove the old arm, check hinge-pin and pivot fit, refit using existing hardware, then verify rear toe and camber to preserve handling balance.

In use the aluminium arm changes dynamic rear response by limiting flex; this can make the car feel firmer and may require small setup adjustments. The light blue finish is cosmetic and does not alter fitment dimensions.

Is JR-M502-LB a direct replacement for the stock arm?

Yes, when your chassis uses the same rear arm mounting geometry the part fits directly without requiring chassis modification.

Should I expect changed handling after upgrading?

Expect reduced flex and a firmer rear response; retune toe, camber or damping if you want to fine tune the new handling characteristics.

Any special maintenance for aluminium arms?

Inspect mounting faces and pivot areas regularly, clean debris, and ensure hinge-pins remain free of wear to maintain a consistent fit.