TAMIYA M-07 Aftermarket Front Steering Knuckle JR-M701-GU by Jazrider  [JR-M701-GU]

Tamiya M-07 Aluminum Front Steering Knuckle (Gun Metal)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-M701-GU
Condition:
Brand New
Available in shop
Write a review

Aftermarket Front Knuckle for M-07

This aluminum front steering knuckle is supplied as an aftermarket upgrade for the TAMIYA M-07 chassis and is finished in gun metal. It replaces the stock plastic knuckle to increase rigidity and provide a firmer steering feel for tuning purposes.

Installation uses standard procedures: remove the wheel hub and original knuckle, transfer compatible bearings and hardware, and secure the new knuckle to the factory mounting points. Verify steering geometry and servo alignment after fitting to ensure correct toe and ackermann.

Used for tuning, the knuckle reduces flex under steering loads and provides a stable pivot surface when paired with suitable bearings and suspension setup. This product is an RC accessory intended for model-scale use only.

Will the JR-M701-GU accept stock bearings?

Yes, stock bearings typically transfer over if they seat correctly in the knuckle bores. Confirm fit before final assembly.

Should I change my steering setup after fitting this knuckle?

After installation it is recommended to recheck and fine tune toe and ackermann as the firmer knuckle can change steering feedback and handling balance.

Is this part suitable for track and club use?

Yes, the part is intended for on-track tuning and club running within model-scale applications, but inspect fasteners and pivots regularly.