TAMIYA M-07 Aluminium Front Steering Knuckle JR-M701-LB by Jazrider  [JR-M701-LB]

Tamiya M-07 Aluminum Front Steering Knuckle (Blue)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-M701-LB
Condition:
Brand New
Available in shop
Write a review

Precision aluminium front knuckle for TAMIYA M-07

The JR-M701-LB aluminium front steering knuckle is a CNC-friendly aftermarket replacement tailored for the TAMIYA M-07 chassis. It replaces the factory plastic knuckle with a denser material to reduce elastic deformation in the steering assembly and extend service life under regular use.

Fitting follows standard M-07 procedures: remove wheel and hub, unfasten the OEM knuckle and install the aluminium knuckle at the factory mounting points. Reuse serviceable hardware, verify kingpin alignment and steering arm posture, and apply the recommended torque to all fasteners to prevent binding while preserving free rotation.

Functionally this part increases steering assembly stiffness without modifying suspension geometry. The result is steadier toe settings and repeatable caster feedback, useful for consistent setup changes. Confirm correct bearing seating and unobstructed hub rotation after installation to maintain precise handling.

What checks should I do after installing JR-M701-LB?

Verify kingpin alignment, check that the steering arm moves freely through its range, and confirm there is no lateral play in the hub bearing.

Are any additional parts required for a standard install?

No extra parts are normally required; reuse serviceable screws and pins and replace any worn hardware to ensure secure mounting.

How does aluminium affect long term wear versus plastic?

Aluminium resists deformation better than plastic under load, so you should see reduced wear and more consistent steering behaviour across many sessions.