TAMIYA M-07 Aluminum Rear Arm Upgrade - JR-M705-RD by Jazrider  [JR-M705-RD]

Tamiya M-07 Aluminum Rear Suspension Arms (Red)
Price:
USD$9.28USD$10.92
Brand:
JAZRIDER
Model:
JR-M705-RD
Condition:
Brand New
Available in shop
Write a review

M-07 Rear Suspension Arm Upgrade

The JR-M705-RD rear arm kit is intended for the TAMIYA M-07 chassis and is machined from aluminum with a red anodized surface. These arms serve as a stiffer replacement for stock plastic arms, aimed at improving rear suspension consistency for model-car use.

Functionally the aluminium arms limit rear flex which can affect toe and camber under load, helping maintain setup through aggressive cornering and higher speed runs. Fit them when aiming for a firmer rear response during tuning or track use on M-07 platform vehicles.

Installation follows conventional M-07 maintenance: remove the original rear arms, attach JR-M705-RD at the chassis' existing mounts, inspect bearings and linkage hardware for wear, and confirm free travel after installation. Avoid over-tightening screws to prevent binding.

Do these arms require extra parts to fit?

No additional custom parts are generally required; JR-M705-RD installs to the M-07 chassis using stock mounting points, though confirm your specific submodel before purchase.

What handling changes should I expect?

Expect reduced rear compliance and crisper rear response. You may need to adjust front or rear roll settings to re-establish your preferred balance.

Maintenance recommendations after upgrade?

Regularly check fastener tightness and pivot areas for wear; verify suspension travel and replace any worn bearings to keep JR-M705-RD functioning as intended.