JAZRIDER JR-TA109-LB Light Blue Aluminum Rear Knuckle Arm for Tamiya TA01/TA02/DF01/FF01  [JR-TA109-LB]

Tamiya TA01 / TA02 / DF01 / FF01 Aluminum Rear Knuckle Arm (Light Blue)
Price:
USD$10.90
Brand:
JAZRIDER
Model:
JR-TA109-LB
Condition:
Brand New
Available in warehouse
Write a review

Practical rear knuckle upgrade for everyday use

The JAZRIDER Aluminum Rear Knuckle Arm offers a straightforward metal replacement for the rear knuckle on Tamiya TA01, TA02, DF01 and FF01 platforms. Finished in light blue, it is intended to reduce common plastic wear points and deliver consistent handling session after session.

What this aluminium arm delivers

This rear knuckle improves resistance to wear compared with original plastic parts while maintaining the same mounting arrangement. It is aimed at hobbyists who prioritise longevity and predictable rear end behaviour without complex modifications.

Fitment and routine checks

Installation follows the same procedure as replacing the stock knuckle on the listed Tamiya chassis. Use standard hand tools, confirm fastener security and verify wheel alignment after fitting to ensure consistent handling.

Is the JAZRIDER JR-TA109-LB a direct replacement for the stock part?

Yes. It is designed to replace the stock rear knuckle on TA01, TA02, DF01 and FF01 chassis using the same mounting points and hardware.

Any special setup changes after fitting this arm?

No special setup steps are required. After fitting, check toe and camber and make minor adjustments as with any suspension work to restore preferred handling.

How should I maintain aluminium suspension parts?

Regularly inspect for wear at pivot points, keep fasteners tight and clean exposed surfaces. A light lubricant at moving interfaces helps preserve smooth operation.