TAMIYA TA01/TA02/DF01/FF01 Aftermarket Aluminum Rear Knuckle - JR-TA109-GU by Jazrider  [JR-TA109-GU]

Tamiya TA01 / TA02 / DF01 / FF01 Aluminum Rear Knuckle Arm (Gun Metal)
Price:
USD$10.90
Brand:
JAZRIDER
Model:
JR-TA109-GU
Condition:
Brand New
Available in shop
2 Reviews
Write a review

Aftermarket aluminum rear knuckle for TAMIYA chassis

This aftermarket aluminum rear knuckle arm is a direct-fit replacement for hobby-grade TAMIYA TA01, TA02, DF01 and FF01 models. It provides a metal alternative to the original plastic knuckle, helping to maintain consistent rear suspension geometry and serving as a robust mounting point for hubs and axle assemblies.

The component is supplied in gun metal and is cut to match stock mounting points so no chassis alterations are typically required. In use it reduces unwanted toe and camber movement under load, supporting stable handling during routine driving and setup.

Fitting the part is a standard swap: remove the OEM knuckle, move bearings or pins across, and secure the new knuckle with the existing hardware. After installation check bearing alignment, suspension clearances and that driveshafts and hub carriers rotate without binding.

 

Product Reviews
2 Reviews
rating
It's my first time ordering from overseas and JAZRIDER did a wonderful job.They were very helpful and their service was quick.Before I know it,my order has already arrived.I am very pleased with the result and I highly recommend this shop.Definitely b
rating
This shop never failed to impress me.You can be assured of fast and quality service every single time.

Is this part compatible with all TA-series rear layouts?

It is compatible with TA01, TA02, DF01 and FF01 chassis that share the same rear knuckle mounting pattern; confirm your exact layout before fitting to avoid mismatches.

Do I need upgraded hardware for track use?

Standard hardware is generally fine for normal use, but consider replacing worn bearings or using higher grade fasteners for intense track conditions to maintain reliability.