TAMIYA TA01/TA02W/DF01/Hotshot Front Upright Knuckle Arms JR-TA101-DB by Jazrider  [JR-TA101-DB]

Tamiya TA01 / TA02W / DF01 / Hotshot Aluminum Front Upright Knuckle Arms (Dark Blue)
Price:
USD$10.68
Brand:
JAZRIDER
Model:
JR-TA101-DB
Condition:
Brand New
Available in shop
Write a review

Machined front uprights for TAMIYA TA-series

This aluminum front upright knuckle arm set is intended for TAMIYA TA-series RC models and is supplied as JR-TA101-DB in dark blue. The components are designed to replace the factory plastic uprights, lowering steering pivot flex and stiffening the connection between the wheel hub and steering linkage while keeping the stock mounting points intact.

Installation notes: uprights accept the vehicle's original kingpin and ball-stud placements and use the existing hub carrier hardware. During trial fitting, confirm ball-stud engagement and wheel hex alignment; small removal of paint or thread-lock on mating surfaces may be required to permit smooth movement. These parts are for scale RC chassis applications only.

Performance notes: aluminum uprights change load transfer through the front suspension, reducing compliance and improving steering consistency under load. After fitting, re-check toe, camber, and steering geometry to re-establish the handling balance you prefer.

Compatibility

  • Tamiya TA01
  • Tamiya TA02W
  • Tamiya DF01
  • Tamiya Hotshot

What is the part number and color for these uprights?

The uprights are listed as JR-TA101-DB and come in a dark blue finish, suitable for TAMIYA TA-series models.

Are these uprights a direct replacement for the stock plastic parts?

They are intended to be direct replacements using the original mounting points; verify clearance and steering geometry during test assembly to ensure proper installation.

What should I check after installing the uprights?

Confirm ball-stud seating, ensure full steering travel without binding, and re-check toe and camber settings after a short test drive to validate handling targets.