TAMIYA TA02 TA03 FF01 CC01 Aluminum Front Knuckle Upright - JR-TA201-LB by Jazrider  [JR-TA201-LB]

Front steering upright for TAMIYA chassis

This aluminum front knuckle arm upright is a direct-fit RC-scale accessory intended for TAMIYA TA02, TA03, FF01 and CC01 chassis. The part replaces the stock plastic uprights to offer a stiffer, more repeatable mounting point for the front steering linkages and wheel hubs. The light blue finish identifies the set but does not change fitment or installation procedure.

Compatibility and role: The component is made as a front steering upright for the listed TAMIYA chassis, serving primarily to stabilize steering geometry and reduce flex under load. It is intended for use on scale electric RC cars only, to assist with tuning steering response and front suspension behavior during track or practice sessions.

Installation notes: Use the original hardware where possible and verify clearance for wheel hexes and brake assembly. Check steering linkage lengths and ackermann after installation, and confirm that the upright clears the shock tower and lower suspension arms through full travel. When tightening, apply thread locker to metal-to-metal fasteners as required by your setup, and test steering throw before full-speed runs.