Tamiya TA07 Rear Suspension Mounts Practical Upgrade - JR-TA705-BK by JAZRIDER  [JR-TA705-BK]

Tamiya 58636 TA07 Aluminum Rear Suspension Mount Set (Black)
Price:
USD$6.50
Brand:
JAZRIDER
Model:
JR-TA705-BK
Condition:
Brand New
Write a review

Practical aluminium rear mounts for TA07

This aluminium rear suspension mount set is intended for use on the Tamiya TA07 chassis, replacing factory plastic fittings with a machined aluminium platform that improves clamp stability for rear linkages and yields a more repeatable geometry baseline for setup work.

Installation follows the TA07 rear pickup and existing mounting points. Remove the original mount, clean mating surfaces, align the replacement in the same orientation and secure using the original fasteners. Use common hex drivers and verify thread engagement to avoid over-torqueing.

Functionally this hop-up increases local stiffness and improves repeatability rather than directly modifying spring or damper rates. It is useful when you want steadier roll behaviour, clearer rear feedback or a reliable platform for subsequent shock and sway bar adjustments. Make incremental setup changes and verify on your typical running surface.

Does fitting require part replacement beyond the mounts?

No additional parts are required in most cases; the mounts are designed to use the TA07 original screws and pickups. Replace any damaged fasteners as needed for secure fitment.

How should I approach setup after installing these?

Treat this as a base change: start with your previous setup, then make small damper or anti roll bar adjustments to suit the firmer mounting and test on-track or at the field.

Are there any routine checks to keep them performing?

Check fastener torque periodically, keep mounting faces free of grit and inspect linkage pivots for play to ensure ongoing consistent performance.