Tamiya TA07/TB04 Pro II Aluminum Rear Suspension Arms JR-TA707-GU by Jazrider  [JR-TA707-GU]

Tamiya TA07/TB04 Pro II (9008169) Aluminum Rear Suspension Arms (Gun Metal)
Price:
USD$11.15
Brand:
JAZRIDER
Model:
JR-TA707-GU
Condition:
Brand New
Available in shop
1 Reviews
Write a review

Aluminum Rear Arm Replacement

This aluminum rear suspension arm kit is a direct-fit option for the Tamiya TA07 and TB04 Pro II platforms, finished in gun metal to combine strength with a low-key appearance for 1/10 touring car applications.

The switch to aluminum alters flex characteristics relative to plastic arms, promoting steadier rear geometry under load and assisting tuners seeking consistent camber recovery and roll control while adjusting springs and anti-roll bars.

Fitting instructions: fit the arms into the existing rear pick points, confirm clearance around drivetrain and servo components, reuse original hardware only if thread and wear are acceptable, and verify all fasteners after the first run.

What basic checks should I do after installation?

Check for proper thread engagement, ensure no contact with moving parts, and perform a torque check on all fasteners after an initial short run.

How should I maintain the anodized finish?

Keep the arms clean and free of grit, rinse off mud and dry thoroughly; light abrasion can be removed carefully but avoid harsh chemicals that strip anodizing.

If an arm is damaged, what is the best practice?

Replace any bent or cracked arms to preserve accurate suspension geometry; minor surface marks can be smoothed but structural damage requires replacement.