JAZRIDER JR-TSD01-LB Blue Aluminium Stabiliser Holder for Tamiya Thunder Dragon / Thunder Shot  [JR-TSD01-LB]

Tamiya Thunder Dragon/ Thunder Shot Aluminum Front Stabilizer Holder (Blue)
Price:
USD$9.90
Brand:
JAZRIDER
Model:
JR-TSD01-LB
Condition:
Brand New
Available in warehouse
Write a review

Serviceable Aluminium Stabiliser Mount for Tamiya Chassis

The JAZRIDER JR-TSD01-LB front stabiliser holder is engineered as a direct aluminium replacement for the standard plastic mount on Tamiya Thunder Dragon and Thunder Shot chassis. The anodised blue component provides a stable attachment point for the stabiliser bar while resisting wear from repeated use.

Practical Benefits for Everyday Use

Upgrading to the JAZRIDER aluminium holder reduces deformation under load and keeps the stabiliser geometry consistent run after run. This yields more repeatable handling and simplifies setup changes when adjusting roll stiffness for different track conditions.

Installation and Maintenance Guidance

Install with standard hand tools, ensuring correct torque on all fasteners. Inspect the mount and fasteners regularly, and clean contact areas to avoid grit build up that can accelerate wear.

Which Tamiya models are supported by JR-TSD01-LB?

This holder is specified for the Thunder Dragon and Thunder Shot front suspension layout. Confirm chassis mounting points match before fitting to other models.

What maintenance keeps the holder performing well?

Regularly remove debris, verify screw torque and check the stabiliser bar interface for signs of wear. Light lubricant on moving connections is sufficient where applicable.

Can this part be used for track and casual running?

Yes. The aluminium holder is suitable for both casual use and more frequent track running, offering improved longevity and consistent behaviour compared with the original plastic piece.