JAZRIDER JR-TFD12-RD Red Aluminum Rear Guard for Tamiya Thunder Shot and Related Models  [JR-TFD12-RD]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Rear Guard (Red)
Price:
USD$9.90
Brand:
JAZRIDER
Model:
JR-TFD12-RD
Condition:
Brand New
Available in warehouse
Write a review

Rear-end protection with practical hobbyist focus

The JAZRIDER Aluminum Rear Guard provides a simple, durable rear protection option for Tamiya Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher platforms. The red anodised plate is intended to shield rear-mounted components from common impact points encountered in recreational and club use.

Compatibility guidance

Manufactured to align with typical rear mounting points on the listed Tamiya models, the guard is designed to fit without permanent chassis modification in standard configurations. Verify mounting clearance if your kit uses aftermarket rear braces or cages.

Installation and upkeep

Install using standard RC tools and tighten fixings evenly. Routine inspection of screw torque and finish condition will maintain performance and appearance through regular running.

What mounting points are used for fitting?

The guard uses common rear chassis mounting locations on the listed Tamiya models. Check your vehicle for aftermarket changes that might alter mounting geometry.

Are there any special maintenance tasks?

Keep the anodised surface clean and inspect fasteners after heavy use. Replace any damaged screws and retighten as necessary to maintain a secure fit.

Does the guard affect clearance or ride height?

The guard adds marginal rear mass but does not significantly alter ride height in normal configurations. If you run a highly tuned setup, factor the small weight change into your balance checks.