TAMIYA TL-01/GF-01/WR-02 Aluminum Front Upper Arm TL01-13300-RD by Jazrider  [TL01-13300-RD]

Tamiya TL-01/GF-01/WR-02 Aluminum Front Upper Suspension Arm (Red)
Price:
USD$5.80
Brand:
JAZRIDER
Model:
TL01-13300-RD
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminum front upper arm

This is a machined aluminum front upper suspension arm designed to suit TAMIYA TL-01, GF-01 and WR-02 chassis. It offers a red anodized finish and preserves the factory mounting geometry to simplify replacement of the stock plastic arm.

Functionally the arm serves as the upper suspension link and retains original ball stud and hinge pin locations. The alloy construction increases stiffness compared to plastic parts, influencing front-end feel and forming part of a broader approach to handling setup.

Installation is straightforward on compatible chassis that share the same upper arm footprint; always check surrounding clearances, confirm ball stud seating, and verify there is no interference with steering components before finalising assembly. Inspect and reuse original fasteners only if they match the arm’s holes and are in good condition.

Compatibility

  • TL-01
  • GF-01
  • WR-02

What should I check before fitting this arm?

Ensure the chassis uses the TL-01/GF-01/WR-02 upper arm footprint, clear any obstructions around the shock tower and steering, and verify ball studs sit correctly in the arm.

Does the upgrade change crash behavior?

Aluminum resists breakage better than plastic but transfers more force to adjacent components; inspect nearby parts after impacts and consider reinforcement where needed.

How do I maintain the anodize finish?

Wipe clean after use, avoid abrasive cleaners, and periodically inspect for scratches or wear; touch-up or replacement may be required if the finish is compromised.