Tamiya TL-01/GF-01/WR-02 Black Aluminum Rear Knuckle Set JAZRIDER JR-TL105-BK - Practical Upgrade  [JR-TL105-BK]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Knuckle (Black) Set
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-TL105-BK
Condition:
Brand New
Available in warehouse
Write a review

Practical aluminium knuckles engineered for reliability

The JAZRIDER Aluminum Rear Knuckle Set JR-TL105-BK delivers a straightforward, durable replacement for Tamiya TL-01, GF-01 and WR-02 cars. Black anodise protects the surface while tight machining tolerances ensure predictable fit and repeatable alignment.

Material and fit considerations

Aluminium knuckles offer improved impact resistance over injection moulded parts and retain geometry under load. These components are dimensioned to match the original mounting points, allowing direct swap with minimal setup change.

Recommended use and maintenance

Ideal for hobbyists seeking a maintenance friendly upgrade, the set suits regular club use and moderate racing. Check mounting hardware for tightness after initial runs and apply medium strength threadlocker where a permanent fit is preferred.

What mounting hardware is required?

Use the stock screws and pins where they are in good condition. Replace any rounded or corroded fasteners to maintain clamping force and correct geometry.

Any torque or threadlocker recommendations?

Tighten fasteners to a firm hand torque and consider a medium strength threadlocker on metal-to-metal joints to prevent loosening from vibration.

How should I inspect them after running?

After a few runs check for play in the bearing bores, any cracking at fastener holes and confirm alignment. Replace or service bearings as needed to preserve performance.