TAMIYA TL-01/GF-01/WR-02 Front Lower Suspension Arm, Red Anodised Aluminium TL01-13302-RD by Jazrider  [TL01-13302-RD]

Tamiya TL-01/GF-01/WR-02 Aluminum Front Lower Suspension Arm (Red)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
TL01-13302-RD
Condition:
Brand New
Write a review

Aftermarket front lower arm for TL-01 range

This red anodised front lower suspension arm is made as a direct replacement for TAMIYA TL-01, GF-01 and WR-02 chassis. The alloy arm increases rigidity at the lower link mounting point versus stock plastic parts, assisting in preserving front-end geometry when driven under load.

It installs using the factory mounting points and standard fasteners; no chassis modification is required. Inspect associated bushings and ball bearings before refitting and ensure hex screws are torqued evenly to avoid introducing alignment variance.

Ideal for setups targeting improved steering precision and repeatability, the arm is suited to firm surfaces and tuning work where consistent geometry is a priority. It is supplied as an aftermarket RC component for scale model use only.

Does the arm require special parts to fit?

No special parts are needed; the arm uses the standard TL-01/GF-01/WR-02 mounting points and common hardware.

How should I check for wear after installing?

Periodically check the connecting bushings and bearings for play and ensure all fasteners remain at the correct torque to maintain alignment.

Will this arm impact tuning choices?

Yes, its increased stiffness can change front response; consider small adjustments to toe and camber during setup to regain your preferred handling balance.