TAMIYA TL-01/GF-01/WR-02 Rear Upper Suspension Arm - Aluminum Red Anodized - TL01-13301-RD by Jazrider  [TL01-13301-RD]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Upper Suspension Arm (Red)
Price:
USD$5.11
Brand:
JAZRIDER
Model:
TL01-13301-RD
Condition:
Brand New
Available in shop
Write a review

Product summary and usage notes

This anodized red aluminum rear upper arm is an aftermarket tuning replacement for TAMIYA TL-01, GF-01 and WR-02 chassis. It installs at the original rear upper mounting points and is intended to improve the consistency of the suspension pivot rather than alter chassis geometry.

The arm reduces flex relative to common plastic parts and provides a firmer pivot surface under load, which can help drivers seeking a more direct rear response. Fitment assumes retention of the stock hardware and suspension tower layout.

Recommendation: check toe, camber and damper settings after replacement and make incremental tuning changes to regain your preferred balance. This product is for RC-scale use only and is not intended for any real vehicle application.

What is the primary benefit of this aluminum arm?

The main benefit is reduced arm flex and a more consistent pivot surface, which can improve predictability in cornering and acceleration phases.

Does installation require modifying the chassis?

No chassis modifications are expected. The part is designed for direct fitment into the stock rear upper mounting points on compatible TAMIYA platforms.

Any tuning advice after fitting?

After fitting, verify wheel alignment and damper settings; modest adjustments to rebound or spring rate are often sufficient to tune the changed rear response.