JAZRIDER TL01-13304-RD Red Aluminium Front Knuckle Arms - Practical Upgrade for Tamiya TL-01/GF-01/WR-02CB  [TL01-13304-RD]

Tamiya TL-01/GF-01/WR-02CB Aluminum Front Knuckle Arms (Red)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
TL01-13304-RD
Condition:
Brand New
Available in warehouse
Write a review

Practical steering upgrade using JAZRIDER TL01-13304-RD

The JAZRIDER aluminium front knuckle arms offer a straightforward durability upgrade for Tamiya TL-01, GF-01 and WR-02CB platforms. Intended for hobbyists seeking reliable front end performance, these knuckles reduce flex and improve steering repeatability without complex setup changes.

Technical compatibility notes

These arms are machined to match OEM mounting points for TL-01, GF-01 and WR-02CB chassis. The red anodised finish adds surface hardness and corrosion resistance while keeping weight low compared with heavier aftermarket parts.

Installation and routine care

Installation is simple with standard RC tools. Fit using original or equivalent quality fasteners, confirm steering geometry after fitting and inspect mounting hardware periodically. Minimal maintenance is required beyond routine cleaning and occasional lubrication of pivot areas.

Do these knuckles need different bearing sizes?

No, they are designed for standard bearing and pivot sizes used on TL-01, GF-01 and WR-02CB setups. Replace worn bearings with equivalent sized parts if needed.

Will fitting affect steering geometry?

Generally the parts are drop-in, but it is good practice to check tie rod lengths and toe settings after installation and adjust as required for optimal handling.

What routine checks should I perform?

Inspect mounting bolts for tightness, clear debris from pivot points and ensure anodised surfaces remain clean. These simple steps keep steering predictable and parts lasting longer.