TAMIYA TT01E/TT01ED Aftermarket Front Upright Knuckle Arms - JR-TT101-LB by Jazrider  [JR-TT101-LB]

Tamiya TT01E / TT01ED Aluminum Front Upright Knuckle Arms (Light Blue)
Price:
USD$11.61
Brand:
JAZRIDER
Model:
JR-TT101-LB
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminium uprights for TT01E

This aluminium front upright knuckle arm set is an aftermarket replacement for the TAMIYA TT01E and TT01ED 1/10 scale chassis. The alloy uprights take the place of the standard plastic units and give a firmer mounting for steering linkages, which helps produce a steadier steering feel during track sessions.

Fit these uprights to tune steering geometry and reduce flex where plastic parts might deform. The blue anodised surface identifies the metal construction and offers basic wear resistance; colour does not alter fit. Confirm wheel hexes, steering links, and ball studs for compatibility before installation.

Fitting steps: remove the stock uprights and transfer any bearings or internal hardware to the aluminium replacements, set turnbuckles to avoid binding, and verify that pickup points for tie rods and dogbones match factory tolerances. These parts are intended for model car chassis use only.

Can I swap these in without changing the steering setup?

Yes, you can generally swap them in and use the existing steering setup, but confirm link lengths and adjust turnbuckles to eliminate any binding introduced by the stiffer uprights.

Do these uprights affect shock or ride height settings?

The uprights themselves do not change ride height, but because they alter steering stiffness you may want to re-evaluate shock settings to restore your preferred balance.

What should I inspect after initial runs?

After the first few runs, recheck fastener torque, ball stud seating, and any signs of metal fatigue or deformation. Address any play or unusual wear immediately.