TAMIYA TT01E/TT01ED Aluminum Front Upright Knuckle Arms - JR-TT101-RD by Jazrider  [JR-TT101-RD]

Tamiya TT01E / TT01ED Aluminum Front Upright Knuckle Arms (Red)
Price:
USD$11.61
Brand:
JAZRIDER
Model:
JR-TT101-RD
Condition:
Brand New
Available in shop
Write a review

Aluminum front upright for TT01E/TT01ED

This is an RC-scale aluminum front upright (knuckle arm) designed for use with TAMIYA TT01E and TT01ED chassis. The part is intended as a direct replacement or hop-up that keeps steering geometry consistent while using a machined metal component instead of stock plastic pieces.

Intended role: replace worn plastic uprights for improved durability, provide a stable mounting point for steering links and allow finer tuning of toe and steering response during setup. Installation typically uses the original steering link pins and hardware, and requires only standard wheel removal and reassembly steps on the TT01E/TT01ED platform.

Compatibility is explicitly TT01E and TT01ED chassis only; do not assume fitment on other TT-01 variants or unrelated models without verification. The part serves as a straightforward upgrade for racers and hobbyists focused on predictable steering feedback and longer service life for front suspension connection points.

Is this a direct bolt-on for TT01E/TT01ED?

It is made to fit TT01E and TT01ED using the stock steering link pins and wheel hubs, so installation is typically direct without modifying the chassis.

Will I need different screws or bearings?

No additional screws or bearings are normally required when replacing TT01E/TT01ED uprights, reuse the original hardware unless noted by your build.

What tuning benefit does aluminum provide?

Aluminum uprights resist deformation better than plastic, keeping steering angles more consistent under load which helps when dialing in toe and steering feel.