TAMIYA TT-02 12mm Hex Wheel Hub Adapter (Red) - TT02-13123-RD TT02-131 by Jazrider  [TT02-13123-RD]

Tamiya TT-02 Aluminum 12mm Wheel Hex Hubs Adapter (Red)
Price:
USD$6.60
Brand:
JAZRIDER
Model:
TT02-13123-RD
Condition:
Brand New
Available in shop
Write a review

12mm Hex Wheel Adapter in Red Anodized Aluminum

This 12mm wheel hex hub adapter is an aluminum replacement designed for use with the TAMIYA TT-02 chassis. Machined from aluminum with a red anodized finish, the adapter replaces the factory plastic hex to provide firmer wheel seating and enhanced durability.

As a direct mounting interface for TT-02 wheels using the 12mm hex, the part reduces play at the wheel-hub joint and promotes more consistent alignment under cornering and acceleration. It is a tuning-oriented upgrade meant to maintain suspension geometry while improving predictability.

Installation uses the TT-02's standard wheel mounting hardware and normally does not require changes to axles or drive components. After installing, inspect surrounding clearances and re-balance wheels as needed to prevent vibration and ensure reliable performance.

Can this adapter be used with non-TT-02 hubs that share the 12mm hex?

It is intended for TT-02 hubs and wheels using the same 12mm hex standard; cross-platform fitment depends on identical hub dimensions and wheel hex profiles.

Will installing metal hex adapters require setup retuning?

Metal adapters can reduce slop and change the way small setup adjustments feel; a brief setup check and test run after installation will help confirm handling and guide any minor tuning tweaks.

How should I verify fitment after fitting these adapters?

After fitting, ensure full nut engagement, check wheel clearance against nearby components, and perform a short run to detect any rubbing or imbalance. Re-torque wheel fasteners afterward.