Tamiya TT-02 Aftermarket Shock Tower Damper Stay, Aluminum - TT02-13113-LB by Jazrider  [TT02-13113-LB]

Tamiya TT-02 Aluminum Front/Rear Shock Tower Damper Stay (Light Blue)
Price:
USD$8.83
Brand:
JAZRIDER
Model:
TT02-13113-LB
Condition:
Brand New
Write a review

Aftermarket aluminum shock tower for TT-02

This machined aluminum front/rear shock tower damper stay is an aftermarket accessory intended for use with the Tamiya TT-02 chassis. The light blue anodized finish supplies firm mounting points for front and rear shocks and supports suspension geometry adjustments and setup work.

Fit this piece when a more robust mounting option is preferred over the original plastic towers; it functions as a stable reference point for experimenting with shock angles and mounting positions. The part is supplied as a chassis accessory and should be installed using screws and hardware that match the TT-02 mounting pattern.

During installation, make sure shock mounts align correctly and tighten fasteners to a secure torque without over-tightening to avoid thread damage. Inspect the anodized surface for any burrs before assembly and confirm clearance with adjacent suspension components through full travel tests.

Is this a direct TT-02 fit?

It is manufactured to match the TT-02 mounting pattern, but check your specific TT-02 variant to ensure exact alignment of hole locations before fitting.

Will I need to modify other parts?

Most installations do not require part modification; however, verify clearances and use appropriate length fasteners. If interference occurs, adjust mount positions or trim adjacent components as needed.

Recommended post-fit checks?

After installation, run the model through full suspension travel, recheck fastener tightness, and inspect for any signs of contact or unusual wear on nearby components.