Tamiya TT-02 Aftermarket Universal Swing Shafts TT02-13117-RD (Red) by Jazrider  [TT02-13117-RD]

Tamiya TT-02 Aluminum Universal Swing Shaft Set (Red)
Price:
USD$9.50
Brand:
JAZRIDER
Model:
TT02-13117-RD
Condition:
Brand New
Available in shop
Write a review

Aftermarket universal shafts tailored for TT-02

The TT02-13117-RD universal swing shaft set is an aftermarket component intended for direct installation on Tamiya TT-02 chassis. Made from aluminum and finished in red, the shafts are designed to stabilise the swing shaft connection and support drivetrain alignment under everyday hobby conditions.

Replacing the stock swing shafts, this set functions as a tuning or replacement item to reduce looseness in the universal joint area and promote smoother transfer of torque from the gearbox to the wheels during acceleration and cornering. It is not a structural modification to the chassis.

Installation follows standard TT-02 service practices: remove affected drive parts, check the new shafts against the originals for correct engagement and length, install, and confirm free rotation and suspension clearance. Use light spline grease at metal-to-metal contact points and re-evaluate after a short test run.

Use alongside routine servicing such as fresh grease, inspected bearings, and correct differential setup for optimal results. Intended for RC model use only and not for use in real vehicles.

How do I check spline engagement?

Align and slide the shaft into the mating spline, ensuring there is full engagement without excessive play; spinning the assembly by hand helps reveal any binding or misfit.

Can these shafts be serviced if scratched?

Light cosmetic scratches do not affect function; for deeper damage inspect for straightness and replace if any bending or spline damage is detected.

What routine checks should I perform after fitting?

After installation, verify free rotation across suspension travel, confirm no binding under load, and re-check spline lubrication following the first test session.