Tamiya TT-02 Aluminum Rear Hub Carrier - Aftermarket Upgrade - TT02-13102-LB by Jazrider  [TT02-13102-LB]

Tamiya TT-02 Aluminum Rear Hub Carrier (Light Blue)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
TT02-13102-LB
Condition:
Brand New
1 Reviews
Write a review

Product overview: aluminium rear hub carrier

This aluminium rear hub carrier is a replacement component intended for the Tamiya TT-02 chassis and is finished in a light blue anodize. It replaces the original plastic carrier to increase rigidity around the rear wheel spindle area, which can influence toe and camber response while tuning.

The part is machined from aluminium to resist flex under load better than stock plastic parts, and the anodized finish gives basic corrosion resistance while maintaining low weight suited to RC use. It is made to fit within the TT-02 rear end layout and to work with the existing wheel mounting hardware and suspension geometry typical of that chassis.

Installation tips: follow standard TT-02 procedures for removal and refitting, check all clearances after fitting, and carry out measured handling tests to evaluate tuning changes.

 

Product Reviews
1 Reviews
rating
The packaging was amazing. Thank you.

Is this compatible with modified rear hubs and wider axles?

Compatibility depends on the specific modifications; while the carrier matches TT-02 geometry, measure clearance carefully on cars with altered hubs or axle widths before installation.

Will switching to aluminium require suspension retuning?

Because aluminium reduces local flex, you may notice a change in chassis feel and should retune toe and camber settings incrementally to restore desired handling balance.

What should I inspect after an impact?

After hard impacts check the carrier for cracks, examine mating hardware for deformation, and verify wheel runout and driveshaft alignment before running the car again.