Jazrider JR-CBR-TM-012 Metal Shielded RC Ball Bearing Set for Tamiya TXT-1 - JR-CBR-TM-012  [JR-CBR-TM-012]

TAMIYA TXT-1 CHASSIS Metal Shielded RC Ball Bearing Set - Jazrider [JR-CBR-TM-012]
Price:
USD$14.38
Brand:
JAZRIDER
Model:
JR-CBR-TM-012
Condition:
Brand New
Available in warehouse
Write a review

Practical bearing upgrade for the TAMIYA TXT-1 chassis

The JAZRIDER Metal Shielded RC Ball Bearing Set provides a 35-piece selection intended to replace wear-prone bushings and factory bearings on the TAMIYA TXT-1. The set focuses on everyday usability and simple, long lasting improvements to rolling components.

Operational advantages of metal shield protection

Metal shields reduce ingress of dust and coarse particles while allowing easy inspection and light servicing. This balance helps maintain smooth rotation without the complexity of fully sealed units, making routine upkeep faster for hobbyists.

Kit composition and intended fitment

This JR-CBR-TM-012 package contains the following bearings to cover standard TXT-1 mounting points:

  • 5 x 11 x 4 mm (8 pieces)
  • 5 x 8 x 2.5 mm (11 pieces)
  • 6 x 12 x 4 mm (16 pieces)

Sizes correspond to common axle, gearbox and wheel positions on the TXT-1. Install evenly and check seating to avoid side loads that can shorten bearing life.

What are the best maintenance practices?

Inspect bearings after dusty or wet runs, clean with a suitable solvent if needed, and apply a small amount of light bearing oil. Avoid over lubrication which can attract grit.

How should I press these into the chassis?

Use a bearing driver or socket sized to contact the outer race and apply even pressure. Do not hammer the inner race directly to prevent brinelling.

Are there any fitment cautions?

Confirm bore and shaft clearances before installation. If a bearing feels tight, check for burrs or misalignment rather than forcing it into place.