JAZRIDER JR-WR101-RD Red Aluminium Shock Tower for Tamiya WR01/WT01 - Front/Rear, 1pc  [JR-WR101-RD]

Tamiya WR01/WT01 Aluminum Front/Rear Shock Tower (1pc)(Red)
Price:
USD$6.90
Brand:
JAZRIDER
Model:
JR-WR101-RD
Condition:
Brand New
Available in warehouse
Write a review

Practical Aluminium Shock Tower for Tamiya WR01/WT01

The JAZRIDER aluminium Front/Rear Shock Tower is a straightforward upgrade for Tamiya WR01 and WT01 chassis. Manufactured as a single aluminium piece, it replaces the stock plastic tower to provide firmer shock mounting and reduce chassis flex under load.

Intended Application

Specifically shaped for the Tamiya WR01 and WT01 layout, the tower fits standard mounting points and can be used in either the front or rear position depending on setup goals. It is suited to hobbyists seeking a durable, everyday upgrade.

Fitting and Maintenance Guidance

Install the tower using proper screws of the correct length and secure them to recommended torque to prevent loosening. Regular post-run inspections and cleaning will maintain reliable service life for the component.

Does this part change ride height?

The tower replaces the stock unit without altering mounting geometry, so ride height is unchanged unless you adjust shock lengths or mounting positions.

What hardware should I use to fit it?

Use the original Tamiya screws where possible or equivalent grade fasteners that match the original lengths to avoid contact with moving parts.

How do I check for wear after use?

Inspect the mounting faces and screw holes for elongation or damage and verify the red finish for scratches that could indicate impact. Replace if any structural deformation is found.