Tamiya WR01/WT01 Shock Tower - JR-WR101-BK by Jazrider  [JR-WR101-BK]

Tamiya WR01/WT01 Aluminum Front/Rear Shock Tower (1pc)(Black)
Price:
USD$6.90
Brand:
JAZRIDER
Model:
JR-WR101-BK
Condition:
Brand New
Write a review

Aftermarket aluminum shock tower for WR01/WT01

This aluminum shock tower is an aftermarket RC-scale part designed for the Tamiya WR01 and WT01 platforms. Supplied as a single black anodized piece marked JR-WR101-BK, it serves as a direct replacement or upgrade point for the shock mounting area on either the front or rear of the chassis.

As a structural hop-up, the tower increases local mounting stiffness and provides a firmer anchor for the shock lower mounts compared with standard plastic towers. That change alters the suspension response, helping to reduce unwanted flex under hard cornering and when using stiffer springs or heavier shock oils.

Installation follows standard RC practice, using the chassis' existing mounting locations and fasteners. Verify fitment to WR01/WT01 mounting points before final assembly and check alignment of shock shafts and mounting screws to avoid binding. No tools or additional parts are included in the listing unless stated by the seller.

Can this part be used on both front and rear of the chassis?

Yes, the design allows it to act as a lower shock mount replacement at either the front or rear positions for WR01 and WT01 models.

Is the JR-WR101-BK supplied with any mounting hardware?

The listing indicates a single anodized tower; confirm with the seller if screws, spacers, or other hardware are included.

What practical effect does this upgrade have?

Expect reduced flex at the mounting area and a firmer suspension response, which can improve cornering precision but may require minor shock and spring adjustments to fine tune handling.