TAMIYA WR-02/DT-03T Aluminum Front Upright Upgrade - JR-WR201-GU by Jazrider  [JR-WR201-GU]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Gun Metal)
Price:
USD$9.20
Brand:
JAZRIDER
Model:
JR-WR201-GU
Condition:
Brand New
Available in shop
Write a review

Aftermarket uprights for TAMIYA WR-02 and DT-03T

The JR-WR201-GU front upright set is an aluminum replacement compatible with TAMIYA WR-02, DT-03T and Blitzer Beetle models shown in the product title. These machined parts feature a gun metal finish and are intended to replace the stock plastic uprights to provide a firmer mount for front hubs and steering links.

Installation aligns with the original WR-02/DT-03T mounting points and commonly reuses stock screws and pins. After refit, check steering geometry and wheel alignment since the stiffer uprights can shift toe and camber behavior under load.

Use the uprights as part of careful tuning: verify compatibility with your knuckles, wheel hexes and bearings and bench-test before running. The JR-WR201-GU focuses on scale suspension tuning and improved durability rather than drivetrain changes.

Which TAMIYA chassis is this intended for?

The listing specifies compatibility with WR-02, DT-03T and Blitzer Beetle platforms. Check your specific chassis variant to ensure matching knuckles and mounting points.

Will existing fasteners and pins work with these uprights?

Most installations reuse the stock hardware, but verify each screw and pin for correct length and thread engagement before final tightening.

Does this upgrade change drivetrain components?

No, the JR-WR201-GU is intended for suspension tuning and visual upgrade. It does not modify the drivetrain, though you should confirm bearing and hex compatibility during fitment.