Jazrider JAZRIDER JR-CBR-TM-042 Metal Shielded Bearing Set for Tamiya XV-01  [JR-CBR-TM-042]

TAMIYA XV-01 CHASSIS Metal Shielded RC Ball Bearing Set - Jazrider [JR-CBR-TM-042]
Price:
USD$15.68
Brand:
JAZRIDER
Model:
JR-CBR-TM-042
Condition:
Brand New
Available in warehouse
Write a review

Practical bearing upgrade for XV-01 maintenance

This JAZRIDER bearing set provides metal shielded units tailored to the TAMIYA XV-01 layout. The shields offer basic contamination control while preserving a low profile for tight fits, making them suitable for routine maintenance and service upgrades.

Kit contents and intended fit locations

The pack supplies the commonly used sizes to swap into hubs, diffs and shaft points on the chassis:

  • 3x6x2.5 - 2 pieces
  • 3x7x3 - 2 pieces
  • 4x8x3 - 5 pieces
  • 5x8x2.5 - 4 pieces
  • 5x10x4 - 9 pieces
  • 10x15x4 - 4 pieces

Metal shields reduce ingress of debris while allowing easy installation in close tolerance housings typical of the XV-01.

Installation and routine service guidance

Use a proper driver to press bearings squarely into their seats and confirm shaft rotation. For longevity inspect bearings after abrasive runs and apply a light bearing oil to maintain low rolling resistance.

Which chassis points use the 5x10x4 bearings?

5x10x4 bearings are typically used in wheel hubs and certain gearbox interfaces on the XV-01. Verify locations against your manual before replacing.

How should I press these bearings in to avoid damage?

Use a bearing press or a socket that contacts only the outer race when seating. Avoid pushing on the inner race to prevent brinelling or misalignment.

Are the metal shields removable for cleaning?

These small metal-shielded bearings are not designed for shield removal. Clean externally and use thin bearing oil to service the raceways without forcing disassembly.