TL-01/GF-01/WR-02 Rear Lower Aluminium Arm JR-TL103-BK by Jazrider  [JR-TL103-BK]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Lower Suspension Arm (Black)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-TL103-BK
Condition:
Brand New
Available in shop
Write a review

Practical aluminium rear lower arm for compatible chassis

This aluminium rear lower suspension arm is supplied as an aftermarket replacement intended for TL-01, GF-01 and WR-02 layouts that share the same rear lower arm mounting pattern. It is provided as a single unit to replace the factory plastic lower arm where the mounting geometry matches the listed models.

The aluminium construction modifies linkage stiffness and pivot wear characteristics relative to molded plastic. The arm is designed to align with the chassis original mounting points and common hardware; installers should trial-fit and reuse compatible screws and pins when appropriate.

From a hobbyist perspective, the arm is selected to give predictable rear-end feedback and improved service life under repeated loading. Check full suspension articulation and confirm no interference after installation to ensure correct operation.

What should I check before fitting?

Verify that the rear lower arm mounting holes and pin diameters on your chassis match the arm. Measure hole spacing and confirm the pivot pins seat without play or excessive tightness.

Is any hardware supplied?

This arm is designed to use the chassis common hardware. Retain and reuse original fasteners where they fit correctly; replace only if length or condition prevents secure installation.

How does aluminium affect maintenance?

Aluminium can reduce wear at pivot points but still requires routine inspection. Check for thread wear, pivot elongation and ensure fasteners remain torqued to prevent slop.