Traxxas TRX-4 Low Profile Gearbox Protector - JR-TRX440 by Jazrider  [JR-TRX440]

Traxxas TRX-4 Stainless Steel Front/Rear Axle Gear Box Bottom Protector Guard
Price:
USD$6.27
Brand:
JAZRIDER
Model:
JR-TRX440
Condition:
Brand New
Available in shop
Write a review

Gearbox Underside Shield for TRX-4

This stainless steel bottom protector is made to cover the lower surface of front and rear axle gearboxes on the Traxxas TRX-4 for scale crawling and trail use. The plate provides abrasion-resistant protection and is not presented as a drivetrain performance upgrade.

Mounting is expected at the underside of the axle housings using standard factory points on the TRX-4; always verify fit and articulate the suspension to check for any interference prior to final installation.

The guard is intended as an aftermarket accessory to reduce underside wear on rocky or debris-filled trails, supporting chassis durability and protecting gearbox surfaces from direct contact.

Do I need to adjust my drivetrain after fitting this?

Generally no drivetrain adjustments are required; however, confirm there is no rubbing on driveshafts or boots after installation and recheck after initial runs.

How often should I inspect the protector?

Inspect the guard after hard trail sessions or notable impacts for dents or loose fasteners, and tighten or replace hardware as necessary to maintain secure protection.

Is the protector compatible with aftermarket axle accessories?

Compatibility depends on the specific aftermarket parts; check clearance and mounting interface with any axle add-ons before final fitting to ensure proper operation.