Traxxas TRX-4M Front Brass C-Hubs (Caster Blocks) JR-TRX4M02-BK by Jazrider  [JR-TRX4M02-BK]

Traxxas 1/18 TRX4M Bronco/TRX-4M Defender Brass Front Caster Blocks (C-Hubs) Set (Black)
Price:
USD$9.50
Brand:
JAZRIDER
Model:
JR-TRX4M02-BK
Condition:
Brand New
Available in shop
Write a review

Brass C-Hubs for TRX-4M Models

The JR-TRX4M02-BK set contains brass front caster blocks (C-hubs) intended for 1/18 scale Traxxas TRX-4M vehicles. These parts are offered as direct replacements for the TRX4M Bronco and TRX-4M Defender and include a black finish.

As functional parts the C-hubs establish front caster geometry and interface with the steering knuckles and hub carriers on the TRX-4M front axle. Brass increases component mass and modifies wear and steering feedback compared to plastic stock parts, influencing front stability on technical terrain.

Before final assembly, verify fitment against the original C-hubs, ensure servo and steering link clearance, and confirm that fastener alignment matches the TRX-4M mounting pattern. The component is for hobby RC use only.

Compatibility: Traxxas 1/18 TRX4M Bronco, TRX-4M Defender.

How can I verify fitment on my TRX4M?

Compare the mounting hole pattern and overall geometry with your stock C-hubs; these are produced to match the TRX-4M front mounting layout for Bronco and Defender.

What handling changes should I expect?

Expect increased front-end weight that can stabilise steering at low speeds and alter the vehicle's balance; tune springs and shock settings if needed to restore desired handling.

Is professional installation recommended?

Routine installation can be performed by experienced hobbyists; however, check clearances and fastener torque carefully and seek assistance if uncertain about fitment or alignment.