TAMIYA TA07 Front Mount Upgrade Plate - JR-TA704-GU by Jazrider  [JR-TA704-GU]

Tamiya 58636 TA07 Aluminum Front Suspension Mount Set (Gun Metal)
Price:
USD$6.04
Brand:
JAZRIDER
Model:
JR-TA704-GU
Condition:
Brand New
Available in shop
1 Reviews
Write a review

Front mount plate for TA07 chassis

This gun metal aluminum front suspension mount set is an aftermarket upgrade intended for installation on the TAMIYA TA07 chassis. It offers a more rigid mounting point for the front suspension tower, which can influence steering response and suspension articulation during tuning.

Fitting follows common TA07 procedures: remove the standard mount, transfer usable hardware and bearings, fasten the aluminum mount to the existing screw bosses, and confirm chassis alignment before track use. Standard hex drivers are sufficient; verify screw lengths and thread engagement to avoid stress on the chassis bosses.

Bench testing shows the mount helps maintain consistent camber and caster when the car is under load, making incremental geometry adjustments behave more predictably. Use measured setup changes and short test laps to confirm handling before extended runs.

Does this mount suit all TA07 models?

The mount is intended for TA07 variants; check that your chassis mounting pattern matches the mount before fitting to ensure correct fitment.

Can I reuse the original screws?

Many installations reuse factory screws, but always confirm screw length and thread engagement so the chassis is not overloaded by incorrect fastener selection.